Headset Top Cap Bolt Torque

You want the minimum torque to reduce play in the headset.

Headset top cap bolt torque.

It is non load bearing. Do not overtighten it. I have it at 5nm now but i still get a click at times. Continue until the play is gone.

A typical torque spec is 4 6 nm. Align your handlebar stem and apply the appropriate torque rating to the steerer tube clamp bolts. What is the correct torque value for the inner bolt on the headset not the cap. Free shipping on your first order shipped by amazon.

Verify that the bars still turn freely with little resistance. Once the stem is tightened in place is is purely cosmetic and covers the top of the steerer. If you feel play loosen the pinch bolts tighten the top cap another 1 8th turn re tighten the pinch bolts and check again. Same is true for the end cap on a shimano hollowtech ii crankset.

Slide your headset spacers and handlebar stem back onto the steerer tube and put the top cap and bolt back on top of the stem and begin to preload the headset by tightening the preload bolt. Get it as soon as tue sep 29. Page 1 of 2 1 2 last. If it matters with a carbon frame.

Torque the pinch bolts. Results 1 to 25 of 34. A torque wrench is a good idea at this point. You will need to loosen stem then tighten this.

As others have said the top cap is pre load only. Top cap is a tiny bit loose. Do up the headset top cap until it is just tight at this point you should be unable to turn your stem spacers.