Fortunately the standards for ada door handle height are not much different than traditional recommendations.
Height of door handle ada.
The 2010 ada standards for accessible design effective 03 15 2012 include an important change relative to the mounting height of hardware.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
Use the try square to make a light 3 inch long horizontal line perpendicular to the grain inward from the mark.
A few exceptions are included in the bill.
Door hardware ada compliant locks exit devices handles pulls latches and other operable parts on doors shall comply operable parts of such hardware shall be 34 inches minimum and 48 inches maximum above the finish floor or ground.
The height of the door handle must be between a minimum of 34 and a maximum of 48.
When sliding doors are fully open operating hardware shall be exposed and usable from both sides.
Staggered design means the handle is longer on one side interior while shorter on the other side corridor.
The selected door handle ladder pull if locking can lock into header ceiling or floor with staggered design.
These federal regulations for door handle height state that door handles must be at least 48 inches from the floor level.
Operable parts shall be operable with one hand and shall not require tight grasping pinching or twisting of the wrist.
Door hardware mounting heights 2010 ada changes.
Lever operated mechanisms push type mechanisms and u shaped handles are acceptable designs.
Handles pulls panic bars.
In the previous edition of the ada standard section 4 13 9 included this statement.
Bottom of pull handle to the finished floor on the corridor side.
The backset is the corresponding vertical mark needed to center the knob.
These formed the basis for the architectural barriers act 1968 the rehabilitation act 1973 the uniform federal accessibility standards 1984 and the americans with disabilities act 1990.
Minimum number at least 60 of public entrances must be accessible in new construction in addition to entrances directly serving tenancies parking facilities pedestrian tunnels and elevated walkways.
Measure up vertically from the bottom corner of the door and make a mark on the edge of the door at the desired height.
What does the ada have to say about door handle height.
Pre existing locks most likely not applicable to new builds gates protecting pools spas and hot tubs are allowed to be a bit higher up to 54.
Hardware required for accessible door passage shall be mounted no higher than 48 in 1220 mm above finished floor.
Ada door handle height requirement.
This guide explains scoping and technical requirements for accessible entrances doors and gates in the ada standards.